A practical reference on heptapeptide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-01-11 and is reviewed periodically as new material appears.
Quality documentation for research-grade peptide usually includes a certificate of analysis stating purity, identity, and residual counterion content. Batch-to-batch variation in purity and salt form is a recognized issue, and comparisons across suppliers require attention to the exact counterion, for example acetate versus trifluoroacetate. Sequence verification by tandem mass spectrometry provides stronger evidence than a single mass measurement. For any study reporting biological results, the analytical method and the measured purity should be stated explicitly. Independent verification of supplier claims is considered good practice.
Semax is supplied as a lyophilized powder that appears white to off-white. It dissolves readily in water, phosphate-buffered saline, and other aqueous media, which simplifies preparation of working solutions for laboratory use. The nasal products registered in Russia are dilute aqueous solutions, typically around 0.1 percent peptide by weight. Organic solvents are rarely necessary and can complicate handling. Because the peptide is hygroscopic, weighing should be performed quickly and with minimal exposure to ambient humidity.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
The compound is registered in Russia as a pharmaceutical product, most commonly formulated as a nasal solution, and has been used in that setting since the 1990s. Outside that jurisdiction it is generally handled as a research chemical rather than an approved medicine. Regulatory status therefore differs sharply between countries, and material sold internationally may not correspond to the Russian pharmaceutical formulation. Documentation with commercial samples is typically limited to a certificate of analysis covering purity and identity, not clinical status or local legal classification.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
| Property | Value | Notes |
|---|---|---|
| Typical purity | ≥95% by HPLC | Research-grade material |
| Detection wavelength | 214 nm | Peptide bond absorbance |
| Reconstitution medium | Sterile water or saline | Prepare fresh or aliquot immediately |
| Storage (solution) | -80 °C, single-use aliquots | Avoid repeated freeze-thaw cycles |
| Common salt form | Acetate or trifluoroacetate | Affects mass and solubility |
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
The C-terminal Pro-Gly-Pro extension is not incidental. Proline-rich tails are known to resist several common peptidases, and the published literature attributes the longer half-life of Semax, relative to unmodified ACTH fragments, to this feature. The modification also removes the melanocyte-stimulating and corticosteroidogenic activity that characterizes longer ACTH-derived sequences. Because the molecule is small and hydrophilic, it is typically formulated as an aqueous solution for intranasal or parenteral delivery. Acetylation or amidation at the termini appears in closely related research peptides and shifts the mass by a fixed increment.
Reported pharmacological work centers on neurotrophic signaling, including changes in BDNF and NGF expression in hippocampal tissue in animal models. Human data come largely from studies conducted in Russia, and how well those results generalize to other populations remains an open question. Regulatory status differs sharply by jurisdiction: Semax is a registered prescription medicine in Russia, while it holds no approved marketing status in the United States or the European Union. Outside such jurisdictions it is generally handled as a research chemical, which affects both documentation and quality expectations.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. It was developed as a fragment analog of adrenocorticotropic hormone, modeled specifically on the ACTH(4-10) region. The first four residues reproduce that fragment, while a Pro-Gly-Pro tripeptide is appended at the C-terminus. Work on the compound originated in Russia, where it entered clinical use as an intranasal preparation. Its sequence places it among short regulatory peptides studied for effects on the central nervous system rather than on the adrenal axis.
=== Toxicity === Overdose from dietary sources alone is unlikely because excess magnesium in the blood is promptly filtered by the kidneys. Overdose is more likely in the presence of impaired renal function. Overdose is likely in cases of excessive intake of supplements. Megavitamin therapy has caused death in a child, and severe hypermagnesemia in a woman and a young girl who had healthy kidneys. The most common symptoms of overdose are nausea, vomiting, and diarrhea; other symptoms include hypotension, confusion, slowed heart and respiratory rates, deficiencies of other minerals, coma, cardiac arrhythmia, and death from cardiac arrest. Inhalation of magnesium oxide in industrial settings can cause metal fume fever.
This last point is actually fairly intuitive: Leaving an adhesive exposed to air too long gets it dirty, and its adhesive strength will decrease. This is observed in the experiment: when mica is cleaved in air, its cleavage energy, W121 or Wmica/air/mica, is smaller than the cleavage energy in vacuum, Wmica/vac/mica, by a factor of 13.
Ricky Dyson (born 28 September 1985) is a former professional Australian rules footballer who played for the Essendon Football Club in the Australian Football League (AFL). Originally from the Epping Football Club, and drafted at number 44 in the 2003 National Draft, Dyson played mainly as a midfielder.
=== LSD substitute overdose === Although LSD is relatively safe in overdose, 25-NB (NBOMe) psychedelics like 25I-NBOMe and 25B-NBOMe are often sold as "LSD" and are highly toxic in overdose, with many reported severe intoxications and deaths. Owing to their high potency analogous to LSD, these drugs are also regularly sold as "LSD" in blotter papers. Fatalities involved in NBOMe intoxication suggest that a significant number of individuals ingested the substance which they believed was LSD, and researchers report that "users familiar with LSD may have a false sense of security when ingesting NBOMe inadvertently". Researchers state that the alleged physiological toxicity of LSD is likely due to psychoactive substances other than LSD. NBOMe compounds are reported to have a bitter taste, are not active orally, and are usually taken sublingually. When NBOMes are administered sublingually, numbness of the tongue and mouth followed by a metallic chemical taste was observed, and researchers describe this physical side effect as one of the main discriminants between NBOMe compounds and LSD. Despite its high potency, recreational doses of LSD have only produced low incidents of acute toxicity, but NBOMe compounds have extremely different safety profiles. Testing with Ehrlich's reagent gives a positive result for LSD and a negative result for NBOMe compounds.
Surface modification has gained a lot of interest in recent years for a variety of applications. An example of the application of free radical polymerizations to forming new architectures is through RAFT polymerizations which result in dithioester end groups. These dithioesters can be reduced to the thiol which can be immobilized on a metal surface; this is important for applications in electronics, sensing and catalysis. The schematic below demonstrates the immobilization of copolymers onto a gold surface as reported for poly(sodium 4-styrenesulfonate) by the McCormick group at the University of Southern Mississippi.
Sources: en.wikipedia.org
Cost Reusability Battery life Ease of use; set-up, readability, download data, analysis, etc. Temperature range Number of measurements stored Accuracy and precision - degree of agreement of recorded temperature with actual Resolution Response time – the time required to measure 63.2% of the total difference between its initial and final temperature when subjected to a step function change in temperature; other points such as 90% are also used. shock and vibration resistance Water resistance – humidity, condensation, etc. Size, weight, mounting Certifications, calibrations, etc. Software Data export Data integration with other systems
April 9, 2010: Canada 17,900 new jobs were created in Canada in the previous month. The trend is moving towards job creation instead of layoffs as seen in late 2008 and most of 2009. Jobs are being created in the private sector while public sector jobs are losing ground. Employment increased marginally in Ontario, Quebec, and Saskatchewan.
Three years later, the 2013 revision of the "phenotypes for the disease course" were forced to consider CIS as one of the phenotypes of MS, making obsolete some expressions like "conversion from CIS to MS". Other organizations have proposed later new clinical phenotypes, like HAMS (Highly Active MS).
Tandem time-of-flight (TOF/TOF) is a tandem mass spectrometry method where two time-of-flight mass spectrometers are used consecutively. To record full spectrum of precursor (parent) ions TOF/TOF operates in MS mode. In this mode, the energy of the pulse laser is chosen slightly above the onset of MALDI for specific matrix in use to ensure the compromise between an ion yield for all the parent ions and reduced fragmentation of the same ions. When operating in a tandem (MS/MS) mode, the laser energy is increased considerably above MALDI threshold. The first TOF mass spectrometer (basically, a flight tube which ends up with the timed ion selector) isolates precursor ions of choice using a velocity filter, typically, of a Bradbury–Nielsen type, and the second TOF-MS (that includes the post accelerator, flight tube, ion mirror, and the ion detector) analyzes the fragment ions. Fragment ions in MALDI TOF/TOF result from decay of precursor ions vibrationally excited above their dissociation level in MALDI source (post source decay ). Additional ion fragmentation implemented in a high-energy collision cell may be added to the system to increase dissociation rate of vibrationally excited precursor ions. Some designs include precursor signal quenchers as a part of second TOF-MS to reduce the instant current load on the ion detector.
The CHMP recommended approval in April 2016, but the FDA rejected the application in November for having insufficient data in November 2016. The drug was authorized in the European Union in May 2016. Germany was the first country where migalastat was launched.
Sources: en.wikipedia.org
Solid peptide is best kept frozen at about minus 20 degrees Celsius in a sealed container with desiccant. It should be allowed to reach room temperature before opening to prevent condensation. Repeated warming and cooling of the same vial is discouraged.
Reversed-phase liquid chromatography establishes purity, while mass spectrometry confirms molecular mass. The two techniques are normally used together. Retention time alone is not sufficient evidence of identity.
Different counterions change the mass per unit of peptide and can shift chromatographic behavior. Two samples of equal stated purity may therefore not be directly comparable. Reports should specify the counterion whenever quantitative comparisons are made.
It is registered as a pharmaceutical product in Russia, where it is typically supplied as a nasal solution. In most other countries it is not an approved drug and is traded as a research chemical instead. Approval status depends entirely on the jurisdiction involved.