lyophilized powder raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2025-10-07. Anything still debated is marked as such rather than presented as settled.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
The compound was developed in the 1980s at the Institute of Molecular Genetics in Moscow, where it emerged from research on short ACTH fragments and their effects on the central nervous system. Russian pharmaceutical listings describe it as a nootropic and neuroprotective agent, most often formulated as nasal drops. It is not a marketed medicine in the United States or the European Union, and no pharmacopoeial monograph covers it. Consequently, most published clinical experience with the substance originates from a small number of research centres, mainly in Russia and neighbouring countries.
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
研究兴趣主要集中在神经营养因子相关的路径上，包括脑源性神经营养因子与神经生长因子的表达变化。部分实验报告称在特定条件下观察到这些因子的水平上升，但具体信号通路和剂量依赖关系仍未完全厘清。多数公开数据来自细胞模型和动物实验，人体对照研究数量有限。因此，该化合物的作用机制在文献中属于活跃讨论，而非已经确立的定论。
Semax 是一种人工合成的七肽，氨基酸序列为 Met-Glu-His-Phe-Pro-Gly-Pro，单字母缩写记作 MEHFPGP。它被归类为促肾上腺皮质激素片段 ACTH(4-10) 的结构类似物，但并不天然存在于生物体内。母体片段 ACTH(4-10) 的序列为 Met-Glu-His-Phe-Arg-Trp-Gly，Semax 替换了中间两个残基，并在羧基端延长了 Pro-Gly-Pro 三肽。这种延长被普遍认为能提升分子对肽酶的耐受性。
该化合物于二十世纪八十年代在俄罗斯被开发，相关工作由俄罗斯科学院分子遗传学研究所的研究团队主导。开发目标并非复制 ACTH 的完整激素活性，而是寻找保留其神经作用方向、同时去除促肾上腺皮质激素释放效应的短肽片段。研究记录显示，这一方向促成了多个相关短肽的合成与筛选，而 Semax 是其中被研究最广泛的一个。当地文献常以 Семакс 这一名称指代它。
Mass spectrometry is used to separate and measure distinct isotopes present in a sample. Archaeologists typically employ isotope ratio mass spectrometers or IRMSs, consisting of an inlet system, ion source, mass analyser and multiple ion detectors. The sample is usually introduced into the mass spectrometer as a gas, with oxygen and carbon being introduced as carbon dioxide. Strontium is too unstable to be easily handled in gas form, instead, it is evaporated and ionised in a vacuum. This use of a solid source is referred to as thermal ionisation mass spectrometry or TIMS. More recently, strontium isotopes have been at the centre of discussion and investigation into the use of laser ablation inductively coupled mass spectrometry (ICP-MS), which is also of interest due to its less invasive nature. Electron bombardment ionises the gas, allowing the molecules to be focused into a beam which is then split by mass into smaller beams - forming a "mass spectrum". The relative intensities of the different beams is then measured in the ion collector and relayed as isotope ratios.
== Further reading == Armstrong PW, Pieske B, Anstrom KJ, Ezekowitz J, Hernandez AF, Butler J, et al. (May 2020). "Vericiguat in Patients with Heart Failure and Reduced Ejection Fraction". N Engl J Med. 382 (20): 1883–1893. doi:10.1056/NEJMoa1915928. hdl:11370/94a25118-d24e-4efa-94a0-3b46279b519c. PMID 32222134.
=== Road to confirmation === When the discovery of a new element is claimed, the Joint Working Party (JWP) of the International Union of Pure and Applied Chemistry (IUPAC) and the International Union of Pure and Applied Physics (IUPAP) assembles to examine the claims according to their criteria for the discovery of a new element, and decides scientific priority and naming rights for the elements. According to the JWP criteria, a discovery must demonstrate that the element has an atomic number different from all previously observed values. It should also preferably be repeated by other laboratories, although this requirement has been waived where the data is of very high quality. Such a demonstration must establish properties, either physical or chemical, of the new element and establish that they are those of a previously unknown element. The main techniques used to demonstrate atomic number are cross-reactions (creating claimed nuclides as parents or daughters of other nuclides produced by a different reaction) and anchoring decay chains to known daughter nuclides. For the JWP, priority in confirmation takes precedence over the date of the original claim. Both teams set out to confirm their results by these methods.
Sources: en.wikipedia.org
===== Chain of two decays ===== Now consider the case of a chain of two decays: one nuclide A decaying into another B by one process, then B decaying into another C by a second process, i.e. A → B → C. The previous equation cannot be applied to the decay chain, but can be generalized as follows. Since A decays into B, then B decays into C, the activity of A adds to the total number of B nuclides in the present sample, before those B nuclides decay and reduce the number of nuclides leading to the later sample. In other words, the number of second generation nuclei B increases as a result of the first generation nuclei decay of A, and decreases as a result of its own decay into the third generation nuclei C. The sum of these two terms gives the law for a decay chain for two nuclides:
=== Production of acrylonitrile === Currently, most acrylonitrile (90% in 2008) is produced by the SOHIO method, which is based on the catalytic oxidation of propylene in the presence of ammonia and bismuth phosphomolybdate. However, until 1960 a key production process was addition of hydrogen cyanide to ethylene oxide, followed by dehydration of the resulting cyanohydrin:
An extension of the WAG algorithm is used, with a new PhyML (WAG+Γ4) model taking into account of sites with different evolutionary rates. Qmaker and nQmaker (2021, 2022), programs with the ability to estimate time-reversible and nonreversible matrices from very large datasets quickly. Each provide a general matrix and 5 specialized matrices, for a total of 12 precalculated substitution matrices. Matrices using a selection of proteins based on structural relatedness, as proposed by Benner et al. (1994), Fan (2004), and Steven et al. (2004). Matrices using structural alignments of proteins instead of simple sequence alignment (6 separate publications). Matrices using known physiochemical parameters of amino acid residues (5 separate publications). For a list of more models (including irreversible i.e. asymmetric and/or specialized ones), see the documentation for recent bioinformatic software including IQ-Tree, PhyML, and RAxML.
=== 2006–2010 === On November 2, 2006, NHK demonstrated a live relay of a UHDTV program over a 260 kilometer distance by a fiber-optic network. Using dense wavelength division multiplex (DWDM), 24 Gbit/s speed was achieved with a total of 16 different wavelength signals. On December 31, 2006, NHK demonstrated a live relay of their annual Kōhaku Uta Gassen over IP from Tokyo to a 450 inches (11 m) screen in Osaka. Using a codec developed by NHK, the video was compressed from 24 Gbit/s to 180–600 Mbit/s and the audio was compressed from 28 Mbit/s to 7–28 Mbit/s. Uncompressed, a 20-minute broadcast would require roughly 4 TB of storage. The SMPTE first released Standard 2036 for UHDTV in 2007. UHDTV was defined as having two levels, called UHDTV1 (3840 × 2160) and UHDTV2 (7680 × 4320). In May 2007, the NHK did an indoor demonstration at the NHK Open House in which a UHDTV signal (7680 × 4320 at 60 fps) was compressed to a 250 Mbit/s MPEG2 stream. The signal was input to a 300 MHz wide band modulator and broadcast using a 500 MHz QPSK modulation. This "on the air" transmission had a very limited range (less than 2 meters), but shows the feasibility of a satellite transmission in the 36,000 km orbit. In 2008, Aptina Imaging announced the introduction of a new CMOS image sensor specifically designed for the NHK UHDTV project. During IBC 2008 Japan's NHK, Italy's RAI, BSkyB, Sony, Samsung, Panasonic Corporation, Sharp Corporation, and Toshiba (with various partners) demonstrated the first ever public live transmission of UHDTV, from London to the conference site in Amsterdam.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is described as a synthetic analogue of the ACTH(4–10) fragment, a short segment of adrenocorticotropic hormone. Its sequence differs from that fragment and includes two proline residues, which influence stability and behaviour in solution.