This is a working overview of mass spectrometry, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-05-01 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Solid material is normally kept at minus 20 degrees Celsius in a sealed, desiccated container. Reconstituted solutions are less stable and are usually divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and loss of activity. Light exposure is minimized by using amber glassware or foil wrapping. Published stability data for this peptide are sparse, so recommended storage conditions rest mainly on general practice for short synthetic peptides rather than on dedicated study.
Identity and purity are commonly assessed by reversed-phase high-performance liquid chromatography, with ultraviolet detection near 214 nanometers for the peptide backbone. Mass spectrometry, either electrospray or matrix-assisted laser desorption, confirms molecular mass and detects truncation or modification products. Amino acid analysis can verify composition. Because the sequence contains no strongly absorbing aromatic residue apart from phenylalanine, detection wavelengths are chosen carefully. Purity values above 95 percent are typical for research-grade material.
Quality documentation for research-grade peptide usually includes a certificate of analysis stating purity, identity, and residual counterion content. Batch-to-batch variation in purity and salt form is a recognized issue, and comparisons across suppliers require attention to the exact counterion, for example acetate versus trifluoroacetate. Sequence verification by tandem mass spectrometry provides stronger evidence than a single mass measurement. For any study reporting biological results, the analytical method and the measured purity should be stated explicitly. Independent verification of supplier claims is considered good practice.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
稳定性主要由水解与氧化两条路径支配。肽键在中性或弱酸性条件下相对稳定，遇到强碱或长时间高温则明显断裂；甲硫氨酸侧链容易被氧化成亚砜，使主峰前移并拉低实际含量。金属离子、光照和反复冻融会进一步促进降解或聚集。冻干粉在低温避光条件下可存放较长时间，配制后的水溶液通常需要冷藏并尽快用完。
纯度评估以反相高效液相色谱为主，通过主峰面积百分比给出粗略结果，再配合电喷雾质谱核对分子量。氨基酸分析可验证组成比例，手性色谱或毛细管电泳用于检查残基构型。常见杂质包括缺失序列的短肽、氧化产物与二聚体。由于多数市售品不附带完整检验报告，独立第三方检测常被用来核实标称值。
==== Antisense oligomer delivery ==== Antisense oligonucleotides (asONs) have been used in basic research and are being developed as possible medical treatments. CPP strategies have been developed to deliver antisense oligomers such as PNA and PMO into cells. Overcoming the repulsion by the cell membrane of negative-charged ONs and the degradation of asONs by enzymes, CPPs increase asONs bioavailability. Two types of neutral ON analogues, peptide nucleic acid (PNA) and phosphorodiamidate morpholino oligomers (PMO or Morpholino) are becoming dominant in this area. PNA has been conjugated with various CPPs either through disulfide linkages or through stable amide bonds. For example, antisense activity within cells that blocked expression of the galanin receptor was observed when a 21-mer PNA was coupled to the penetratin. Results on antiviral activity with PNA targeting HIV-1 have also been reported through disulfide linkage with TAT. CPP-PMO conjugates have also been successfully used to inhibit the replication of several viruses such as SARS and influenza and attachment of CPPs has improved the efficacy of splice-modifying Morpholinos in development for treatment of Duchenne muscular dystrophy
This practice can make drugs of otherwise indispensably potent value more tolerable to certain patients and spare them needless suffering, hence-reducing the overall side-effect burden or concern thereof. Although clomipramine shows around 100- to 200-fold preference in affinity for the serotonin transporter (SERT) over the norepinephrine transporter (NET), its major active metabolite, desmethylclomipramine (norclomipramine), binds to the NET with very high affinity (Ki = 0.32 nM) and with dramatically reduced affinity for the SERT (Ki = 31.6 nM). Moreover, desmethylclomipramine circulates at concentrations that are approximately twice those of clomipramine. In accordance, occupancy of both the SERT and the NET has been shown with clomipramine administration in positron emission tomography studies with humans and non-human primates. As such, clomipramine is in fact a fairly balanced SNRI rather than only a serotonin reuptake inhibitor (SRI). The antidepressant effects of clomipramine are thought to be due to reuptake inhibition of serotonin and norepinephrine, while serotonin reuptake inhibition only is thought to be responsible for the effectiveness of clomipramine in the treatment of OCD. Conversely, antagonism of the H1, α1-adrenergic, and muscarinic acetylcholine receptors is thought to contribute to its side effects. Blockade of the H1 receptor is specifically responsible for the antihistamine effects of clomipramine and side effects like sedation and somnolence (sleepiness).
At first Coleridge welcomed the relief from pain provided by Kendal Black Drop, but was later to say that his "eyes had been opened to the true nature of the habit into which I had been ignorantly deluded by the seeming magic effects of opium".
Sources: en.wikipedia.org
=== Other liquids === For example, hydrogen fluoride—which has three lone pairs on the F atom but only one H atom—can form only two bonds. Ammonia has the opposite problem: three hydrogen atoms but only one lone pair.
The Br–Br distance is 227 pm (close to the gaseous Br–Br distance of 228 pm) and the Br···Br distance between molecules is 331 pm within a layer and 399 pm between layers (compare the van der Waals radius of bromine, 195 pm). This structure means that bromine is a very poor conductor of electricity, with a conductivity of around 5 × 10−13 Ω−1 cm−1 just below the melting point, although this is higher than the essentially undetectable conductivity of chlorine. At a pressure of 55 GPa (roughly 540,000 times atmospheric pressure) bromine undergoes an insulator-to-metal transition. At 75 GPa it changes to a face-centered orthorhombic structure. At 100 GPa it changes to a body centered orthorhombic monatomic form.
EDE is a synthetic estrane steroid and the C3 and C17β heptanoate (enanthate) diester of estradiol. It is also known as estradiol 3,17β-heptanoate or as estra-1,3,5(10)-triene-3,17β-diol 3,17β-diheptanoate. EDE is structurally related to estradiol enanthate (estradiol 17β-heptanoate), which has a single heptanoate ester rather than two.
=== Iron chelation === Multiple blood transfusions lead to severe iron overload, as the body eventually breaks down the hemoglobin in donated cells. This releases iron which it is unable to excrete. Iron overload may be treated by chelation therapy with the medications deferoxamine, deferiprone, or deferasirox. Deferoxamine is only effective as a daily injection, complicating its long-term use. Adverse effects include primary skin reactions around the injection site and hearing loss. Deferasirox and deferiprone are both oral medications, whose common side effects include nausea, vomiting and diarrhea.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Solid peptide is best kept frozen at about minus 20 degrees Celsius in a sealed container with desiccant. It should be allowed to reach room temperature before opening to prevent condensation. Repeated warming and cooling of the same vial is discouraged.